导航:首页 > 装置知识 > 乳化液自动配比装置制造厂家

乳化液自动配比装置制造厂家

发布时间:2023-02-11 01:30:52

① 认识乳化液泵站的优点sh10

乳化液泵站主要是为普采工作面提供高压乳化液,作为液压支架和推移工作面运输机中煤时的动力源。该泵站由二台乳化液泵与一台乳化液箱组成,其中一台泵工作,另一台泵备用。
乳化液泵站产品优点
1、流量大:125L/min,工作面500m以上,同时配备多把注液枪,工作效率高。
2、能耗低:仅11kW,同流量传统泵站需要耗能55kW;配套电器设施要求低。
3、轻便节能、易移动、使用灵活、自动配比乳化液。
4、用途广:高压达38.5MPa,可兼做试验台使用,也可调至6-8MPa,做煤层注水及喷雾除尘使用。
5、使用寿命sh10长:可连续24小时工作。
6、操作阀采用不锈钢制做;自动配比乳化液、超压保护、自动卸荷、空载运行功能;长久闲置不生锈,能即时正常使用。
7、价格实惠:两泵一箱,比传统泵站价位相对低。

② 煤矿乳化液配比有哪些防范措施

根据相关资料显示煤矿安全规程乳化液配比浓度标准乳化液泵站和液压系统完好,不漏液,压力≥18MPa(综采≥30MPa),乳化液浓度不低于2%-3%(综采3%-5%),使用乳化液自动配比器,有现场检查手段。

③ 有什么使用寿命长的LED照明灯

节能灯因节能而受欢迎,一个9瓦的节能灯相当于40瓦的白炽灯。节能灯的寿命也比较长,一般是8000-10000小时。节能灯的显色度在80左右,部分产品可达到85以上,显色度也比较高。
节能灯的照度范围在2700K-6500K之间,因此节能灯有黄光和白光两种灯光颜色供选择。一般人心理上觉得黄光较温暖,白光较冷,现在很多五星级酒店喜欢用黄色暖光的节能灯,效果也很好。
品质高的节能灯会使用真正的三基色稀土荧光粉,在确保长寿命的同时,还能保持较高的亮度。正常使用节能灯一段时间后,灯就会变暗,主要因为荧光粉的损耗,技术上称为光衰。有些品质较高的节能灯发明了恒亮技术,可以让灯管长久保持最佳工作状态,使用2000小时后,光衰不到10%。

④ 乳化液配比器在水箱什么位置用

顶部左侧。乳化液配比器是一种需要用电的设备,为了避免水温升高,水箱内产生的潮气、温度对电气设备造成影响,乳化液配比器需要在水箱的顶部左侧使用。乳化液配比器是矿上使用单体液压支柱时必须使用的配备器材,为单体液压支柱配比乳化液,其原理是通过继电器的通断来控制阀门开闭,从而确保泵箱内的乳化液和水在一定液面范围内自动配比供液。

⑤ 乳化液泵配件厂家

乳化液泵配件厂家有无锡市勤达特种泵配件厂。乳化液泵各类配件大全介绍的特点更换时,必须有一个人在外面监护,新泵或较长时间停车的泵,应首先检查各零部件有无损伤,冰冻与锈蚀等现象密封是否完好,安装是否正确检查时应做到仔细认真。

乳化液泵配件的特点

乳化液泵各类配件大全乳化液泵具有流量均匀,压力稳定运转平稳强度高,脉冲小油温低噪声小和使用维护方便等特点,所以还广泛适用于管道清洗工件清洗,玻璃清洗和工程掘进等,齿轮装置的主要零件由数控心制造,工精度大大提高,输送机哑铃销齐全,溜槽间隙符合规定,无断,三机通讯系统报警完好,锁定装置灵敏可靠。

⑥ 乳化液自动配比器主要技术参数sh08是什么,谢谢

乳化液自动配比器为使用乳化液为工作介质的各种设备进行自动配比的设备。在 普采和综采工作面上广泛使用。
乳化液自动配比器特点
乳化液自动配比器集进中煤水与吸油为一体,自动化程度高,基本上不受水压变化的影响。
乳化液自动配比器主要技术参数
乳化油箱容积:25升;40L
配比调节范围:1.5-5%
进水压力:≥5.5kgf/cm2
重量:8KGsh08
容量:30L。

⑦ 乳化液泵站厂家

山东中煤乳化液泵站应用在各种矿山、国防、隧道及坑道作业。为采煤工作面,掘进机提供高压乳化液,满足普采工作面,综采工作面的不同要求。

乳化液泵站是用来向综采工作面液压支架或高档普采工作面单体液压支柱等输送高压乳化液的设备。能实现推移刮板运输机、移架、调架、护壁、防倒、防滑等动作。

原因是乳化液泵站供给的压力液使各种千斤顶动作的结果。所以说,乳化液泵站是液压支架的动力源,它的好坏直接影响着液压支架的工作性能和使用效果。

启动前的检查:

各部件的连接螺栓是否齐全、牢固,特别要仔细检查泵柱塞盖的螺钉。

泵站至工作面的管路接头连接是否牢靠、漏夜。

各截止阀的手柄是否灵活可靠、吸液阀、手动卸载阀及工作面回液阀是否在开启位置,向工作面供液的截止阀是否在关闭位置,各压力表是否齐全、完整、动作灵敏。

乳化液有无析油、析皂、沉淀、变色、变味等现象;用折射仪检查乳化液配比浓度是否符合规定,液面是否在液箱的2/3高度位置以上,润滑油是否达到规定位置。

⑧ 矿山机械的论文摘要翻译。。。求各路大虾帮忙了啊

Emulsion in coal mine to play a very important role, as the hydraulic mining machinery working media, particularly mine coal face, as hydraulic and hydraulic prop of the working media in the coal mine has been widely used mine support equipment known as the blood. In recent years, with the rapid development of coal instry, the ratio of adding liquid emulsion and its application is now gaining more attention.
With the rapid development of science and technology, with fully mechanized coal face the demand for high yield and efficiency, the ratio of the emulsion quality of higher and higher requirements. At present, China plus the ratio of liquid emulsion of research has made some progress, but there are many problems. Mainly to the following conditions: 1, emulsion concentration and preparation to meet proction requirements clumsy way to make workers labor intensive, difficult to adapt the automation needs of coal proction; 2, increased automation, but the concentration of emulsion below standard, will not achieve its proper role, it is even an immeasurable loss to the proction; 3, emulsion concentration and automation requirements have been met, while the cost of proction has substantially increased, will not achieve increased coal proction benefits.
In view of this situation, put forward in development of automatic matching plus liquid emulsion system, in order to solve our country in the liquid emulsion ratio increases the problem there's trouble. Thesis of emulsion can be used independently automatic matching system, but also with the current development is mature with a large pumping station emulsion used to provide power to the fully mechanized coal face. Addition to using the automatic matching of emulsion by extension, could be used as temporary power sources used for light pumping system.
The subject of the mechanism-based emulsion formulated based on the theory, the ratio in the emulsion is to use part of the Venturi tube by high-speed water pipes in their place to proce negative pressure to suction up oil ratio of the working principle, and the higher degree of automation systems, the emulsion with the concentration can completely meet the "Coal Mine Safety Regulations" requirements. Same subject from a practical, functional perspective, the ratio of emulsion after the emulsion automatically through automatic device used in light liquid pumping system to automatically increase the ratio of emulsion liquid automatic functions combine with the pumping station in together, can achieve the preparation of emulsion side to side Face to power functions. The emulsion with the concentration of not only meet the requirements of proction and adjustable within a certain range, effectively avoiding the emulsion in storage too long and there's mold, oil analysis of the phenomenon.
The paper also the main functional elements of the design, characteristics and internal flow field emulsion carried out a detailed theoretical analysis, and further to deepen their study provides a theoretical and practical basis.

Keywords: emulsion Venturi pump automatic auto-liquid ratio of light

⑨ 乳化液泵站厂家

南京六合鼎扬制泵有限公司是开展乳化液泵站的厂家。

南京六合鼎扬制泵有限公司位于美丽的南京市六合区龙池湖畔,从事机械制造业已有近二十年历史。公司现有员工120余人,各种生产,检验设备200余台。

公司现主要产品有:煤矿用乳化液泵,喷雾泵站和各种阀类及配件,品种型号齐全。

南京六合鼎扬制泵有限公司于2005年04月30日在南京市六合区市场监督管理局登记成立。法定代表人林琼,公司经营范围包括乳化液泵、水泵、包装设备、自动化设备研发等。

南京六合鼎扬制泵有限公司公司理念:

公司一直奉承“用户是总裁,质量是生命”的宗旨。凭着一份真挚的社会责任,精心制作,在广大用户中有着良好的声誉。公司具有相关的产品“煤矿安全标志”资格,并通过ISO9000质量体系认证。

真诚希望全国尊贵的客户选用我公司的产品,欢迎来我公司做客!我们将向你提供最放心的产品,最周到的服务。伸出你的手我们就是朋友!

⑩ 乳化液自动配比装置

一般按产品说明书进行配比,如果没说明书,则一般为2%-10%要看你使用时强调的是它的冷却性(2%-5%),还是润滑性(5%-10%甚至可达20%)

阅读全文

与乳化液自动配比装置制造厂家相关的资料

热点内容
一条检测线的设备需要多少钱 浏览:62
暖气片回水阀门是什么阀 浏览:647
仪表盘控制柜怎么接线 浏览:608
制动传动装置的布置形式 浏览:519
生化仪器试剂过期怎么改 浏览:315
广东精艺发五金制品厂 浏览:646
神经网络数据训练工具箱 浏览:756
领界仪表显示模式怎么设置 浏览:530
东莞市有哪些日资五金制品厂 浏览:895
管道泵一般用什么阀门 浏览:790
阀门DN150A是什么意思 浏览:974
超声波液位计sl什么意思 浏览:830
机械三位开关怎么接线图 浏览:935
彩镀设备一般多少钱 浏览:522
调制冷水面主坯主要用什么手法 浏览:656
家用暖气阀门开关进户阀 浏览:754
机械设计工作室怎么开 浏览:281
自动化高度检测装置 浏览:11
怎么建造机械车迷你 浏览:649
实验室制乙酸乙酯装置改装 浏览:757